Buy article PDF
The purchased file will be sent to you
via email after the payment is completed.
US$ 35
|
Computers and Concrete Volume 21, Number 6, June 2018 , pages 705-715 DOI: https://doi.org/10.12989/cac.2018.21.6.705 |
|
|
|
Curing effect on mortar properties produced with styrene-butadiene rubber |
||
Selim Cemalgil, Serkan Etli and Onur Onat
|
||
| Abstract | ||
| This paper presents an experimentally investigation pertinent to the mechanical properties of rubberized mortar (RM) with styrene-butadiene rubber (SBR). The SBR were used with constant water-to-cement ratio of 0.485 and two different volume proportion of SBR particles were utilized as aggregates. One types of SBR particles with fineness modulus of 4.951 were utilized 0%, 10%, and 20% of aggregate volume. Effectiveness of SBR replacement ratio, curing and aging effect on the compressive strength, flexural strengths as well as load-displacement. Compressive and flexural strength of concrete were investigated at the end of 28-days and 56-days age. Obtained results demonstrated that utilization of SBR reduced the flexural strength of SBR mortar at the earlier curing age while SBR increased. Moreover, mechanical properties of mortar mentioned above were significantly affected by the water cure timing with an increasing proportion of the replacement level of SBR. | ||
| Key Words | ||
| fineness modulus; styrene-butadiene rubber; mechanical properties; rubberized mortar | ||
| Address | ||
| Selim Cemalgil, Serkan Etli and Onur Onat: Civil Engineering Department, Munzur University, 62000, Tunceli, Turkey | ||